martensite造句

1、The results show that the microstructure was mainly composed of martensite and lower-bainite.
结果表明，实验钢的组织以马氏体和下贝氏体为主。

2、These lath martensite first nucleates in parent austenite intergranular and twin boundary.
应变诱发马氏体首先在原奥氏体晶界和孪晶界形核。

3、Failure Analysis on Quenching Cracking of High Carbon Martensite Steel Ball
高碳马氏体钢球淬火开裂失效分析

4、Rapid cooling after nitrocarburizing, martensite structure is obtained at the diffusion layer.
氮碳共渗后快冷，在渗层获得含氮碳的马氏体组织。

5、The microstructure of surfacing metal is lath martensite and carbide.
堆焊层显微组织为低碳马氏体和碳化物。

6、This equation reflects the special character of martensite phase transformation well.
该方程能较好地反映马氏体相变特征。

7、TEM Study on Relative Orientation Between Adjacent Martensite Laths
相邻板条马氏体间位向关系的TEM研究

8、No deformation martensite phase was discovered.
没有发现形变诱发马氏体相。

9、The structure of the studied steels was bainite, martensite and retained austenite.
研究用钢的室温组织为贝氏体、马氏体、少量残余奥氏体。

10、They are dislocated lath martensite area and twinned martensite area respectively.
这些微区分别为内孪晶马氏体区和位错板条马氏体区。

11、Tempered Martensite Embrittlement in a 5Cr_4 Mo_3 Si Mn VAl Matrix Steel
5Cr_4Mo_3SiMnVAl基体钢回火马氏体脆性

12、The interface of austenite and martensite is somewhat straight.
奥氏体和马氏体之间的界面为较平直的界面。

13、INFLUENCE OF CARBON ON MICROSTRUCTURE OF MARTENSITE IN Fe—C ALLOYS
含碳量对Fe—C合金马氏体形态的影响

14、Erosive Wear of High—Cr Cast Iron With Austenite or Martensite Matrix
奥氏体基体和马氏体基体高铬铸铁的冲蚀磨损特性

15、The deformation dislocation density and martensite microstructure were also analysed by TEM.
采用TEM对形变位错密度以及马氏体组织进行了分析。

16、APPLICATION OF ISOTHERMAL MARTENSITE IN GCr15 BALL-BEARING STEEL
GCr15轴承钢中等温马氏体的应用

17、The Grain Refining Process for 18Ni(2450MPa) Martensite Aged Steel
18Ni(2450MPa级)马氏体时效钢细化晶粒工艺

18、Fine structure of martensite in M-A constituents is twin sub structure.
组元中马氏体的精细结构为孪晶亚结构。

19、FORMATION MECHANISM OF ISOTHERMAL MARTENSITE IN 1C-1.5Cr BALL BEARING STEEL
1C-1.5Cr轴承钢中等温马氏体的形成

martensite翻译